Orthotic Additions

Interpod provide the two most used Forefoot Addition designs – a PMP and a Lateral pad, each available in three sizes – S, M and L.

We also provide two Heel Lifts, the Small size (4mm) and Large size (6mm) in thickness.

Heel Lifts

Product Description

Heel lifts are used to fine tune and improve orthotic prescription outcomes in particular patients with decreased ankle dorsiflexion. Often this is determined by doing a Lunge Test. Patients with limited ankle dorsiflexion may find the orthotic pushes up into their arch causing discomfort. Using a heel lift increases ankle dorsiflexion and orthotic comfort. Heel lifts are also used to treat patients with limb length differences.

ENQUIRE ABOUT PRODUCT

PMP Forefoot Pads

Product Description

Interpod orthotic additions are used to fine tune and improve orthotic prescription outcomes

In particular patients with 1st Ray/1st metatarsal issues and forefoot pain will respond to a forefoot pad.

The PMP pad Is used for 1st Ray and Metatarsal issues as well as general forefoot pain and to re-distribute pressure from the Met Heads. It is also used to create a Reverse Windlass effect for patients with claw toes and can be trimmed to form a Met Bar for Morton’s Neuroma.

ENQUIRE ABOUT PRODUCT

Lateral Pads

Product Description

The Lateral Pad is used mainly to improve the Windlass Mechanism. This is achieved by elevating Mets 2-5, allowing the 1st Met to plantar flex an increasing dorsiflexion of the Hallux. The Windlass is important during the supination phase. Lowering the effort needed to tighten the Plantarfascia takes load and stress from the patients soft tissues, decreasing muscular effort and therefore the likelihood of injury.

ENQUIRE ABOUT PRODUCT

Full Length Top Cover

Product Description

Replaceable top covers for Interpod Orthotics. Eliminate any grinding or time consuming work needed to remove and replace top covers. The Interpod EVA top covers are easy to use and highly cost effective and time efficient compared to those used on Custom made orthotics. There is no need to grind the cover from the orthotic shell. Simply peel the back paper off and stick the cover to the orthotic shell. The covers provide added cushioning and improve the fit to the shoe and will last the life of the shoe before needing replacement.

ENQUIRE ABOUT PRODUCT

3/4 Top Cover

Product Description

The 2mm EVA replaceable top covers are easy to use. Simply peel the back paper off and stick the cover to the orthotic shell. The covers provide added comfort and cushioning and will last the life of the shoe. Covers do increase the thickness of the orthotic, so you may prefer not to use a cover in tight footwear.

ENQUIRE ABOUT PRODUCT